NEC Electra Elite IPK Programing Manual page 425

Document Revison 1
___________________________________________________________________________________
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Selection
1-16-00 Auto Negotiation Yes/No Selection
1-16-01 Port Speed Selection – 10/100 Base T
1-16-02 Port Duplex Mode Selection
1-16-03 MDI/MDIX Mode Selection
1-16-04 VLAN Mode Selection
1-16-05 Default VLAN ID Assignment
1-16-06 Port Based Priority Selection
1-16-07 High Priority RX Tag Assignment
1-16-08 High Priority TX Tag Assignment
1-16-09 Low Priority TX Tag Assignment
1-16-11 Mirroring Source Port Assignment
1-16-12 Mirroring Target Port Assignment
1-16-13 VLAN Group to VLAN ID Assignment
VLAN Group and Port Selection
1-16-14
VLAN Tag Insertion Selection
1-16-15
Flow Control for Full Duplex Selection
1-16-16
Back Pressure for Half Duplex Selection
1-16-17
1. Only one HUB(8)-U( ) ETU can be assigned and installed for each cabinet.
2. The HUB(8)-U( ) ETU is an eight-port switching HUB. One port can be set as a source port, and one port can be
set as a target port for port mirroring to monitor traffic data.
3. To allow this function, set this Memory Block to YS, and program Memory Block 1-16-11 (Mirroring Source Port
Selection) and Memory Block 1-16-12 (Mirroring Target Port Selection).
___________________________________________________________________________________
3 - 354
Notes
Elite IPK
Memory Blocks