NEC Electra Elite IPK Programing Manual page 348

Elite IPK
___________________________________________________________________________________
1-13-01 PRT Signal Format Selection
General Description
Use this Memory Block to specify the signal format of the PRT trunk connected to the system.
The signal format used (12- or 24-Multiframe) depends on the channel service unit/demarcation
(CSU/D mark) equipment being used.
Display
D a t a
P R T
N o .
1 ~ 8
0 1 / 0 1 : F R A M E = 2 4
T I M E
Settings
LK 1 LK 2
12 24
(SF) (ESF)
Programming Procedures
1 Go off-line.
K A
2 Press LK1 + LK13 +
G
3 Press the corresponding CO/PBX line key to change the data option.
4 Press to write the data. The next Memory Block2 is displayed.
5 Program the next Memory Block2 or press
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
T i t l e
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK 8
Document Revision 1
System Mode
1
Submode
13
Data No.
01
PC Programming
+AN
The shaded
selection is the
default.
2 - 277