Removing The Power Supply (Low-Profile Models); Figure 3 - 16 Releasing The Latch; Figure 3 - 17 Removing The Low-Profile Models Power Supply - Digital Equipment CELEBRIS Pentium PC Service Maintenance Manual

Digital CELEBRIS Pentium PC

Removing the Power Supply (Low-Profile Models)

To remove the power supply:
1) Perform the steps necessary to open the device bay and power supply subassembly.
2) Remove power supply, IDE, and diskette cabling from main logic board noting their proper
orientation.
3) While holding the device bay and power supply subassembly, carefully release the rear latch.
4) Carefully slide entire subassembly away from chassis and place upside down on antistatic surface.
5) Loosen two screws securing power on/off switch to chassis.
6) Remove screws securing power supply to chassis.
7) Remove power supply and power on/off switch from the subassembly.
MCS Logistics Engineering - Nijmegen

Figure 3 - 16 Releasing the Latch

Figure 3 - 17 Removing the
Low-Profile Models Power
Supply
Service Procedures
49