Appendix A: Moving The Libraries; Move The Library System Out For Access; Figure A-1: Leveler Reference Marks On Floor - Overland Storage NEO 8000 Remove & Replace Instructions

If the library system must be moved, follow the following procedures to move it out, move it
back, and then level the units.

Move the Library System Out for Access

The libraries must be powered so that the drawers and mail slot can be removed before
attempting to move the library system.
WARNING: Use care when removing the media drawers. Fully-loaded drawers weigh
approximately 58 pounds (26.4 kg). Exercise care when removing the drawers from the
libraries.
1. With the power On, release and remove all the media drawers from both the Master
and Slave units.
2. Release and remove the Mail Slots from both units.
WARNING: Working with a powered NEO 8000 library may cause physical harm and
severe damage to unit's circuitry. Always power down a library before removing any
panels.
3. Power down both units.
a. Turn off the Slave unit.
b. Turn off the Master unit.
c. Set each of the library circuit breakers to the OFF ("O") position.
d. Remove and retain the power cords.
4. Verify that the library leveler reference marks are still visible on the floor (see
Figure A-1). If necessary, remark the location and position of the levelers.
Part Number 104372-102 08/2005

Appendix A: Moving the Libraries

Figure A-1: Leveler Reference Marks on Floor

A–1