Harness-Assy Feed 1 - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.13.16 HARNESS-ASSY FEED 1

REMOVAL
1. Remove 500 PAPER FEEDER ASSY.
2. Remove COVER LEFT 500. (p.453)
3. Unclamp the clamp fastening the harness of HARNESS-ASSY FEED 1.
4. Disconnect connector (P/J435) from PWBA-TRAY 500.
5. Unhook the 2 hooks fastening HARNESS-ASSY FEED 1 to 500 PAPER
FEEDER ASSY, and remove HARNESS-ASSY FEED 1.
REINSTALLATION
1. Pass the connector (P/J43) on HARNESS-ASSY FEED through the hole on 500
PAPER FEEDER ASSY.
2. Attach HARNESS-ASSY FEED 1 to 500 PAPER FEEDER ASSY, and fasten
with the hook.
3. Connect connector (P/J435) to PWBA-TRAY 500.
4. Fasten the harness of HARNESS-ASSY FEED 1 with the clamp.
5. Attach COVER LEFT 500. (p.453)
6. Attach 500 PAPER FEEDER ASSY.
Table 4-16. Symptoms when the connector is loose
Connector
Panel Indication Symptom
No.
Printing is not
P/J435 Service Req E547
possible.
DISASSEMBLY AND ASSEMBLY
(p.452)
(p.452)
Error Caused by Connector
Disconnection
Paper Feeder cannot be detected.
500 PAPER CASSETTE & 500 PAPER FEEDER
5)-1
5)-2
3)
3)
4)
Figure 4-162. Removal of HARNESS-ASSY FEED 1
Revision B
Leg_Sec03_026FA
462