Epson AcuLaser C1100 Service Manual page 260

EPSON AcuLaser C1100
FIP-P14 Image Not Fixed
Before starting troubleshooting, inspect the feed path of the printer paper. Check the
paper feed path for metal staples, paper clips, paper scraps, and other foreign matter.
Step Check
Check of Paper
1
Load new, dry recommended paper, and
execute a test print.
Is the image printed normally?
Check of print setup mode
2
Is the printer set to a Transfer Voltage suited
to the type of paper in use?
Check of Heat Roll and Pressure Roll
3
W A R N I N G
Allow FUSER ASSY to cool down
before performing work.
Remove FUSER ASSY. (p.388)
Turn the Gear by hand, and inspect Heat Roll
and Pressure Roll.
Are Heat Roll and Pressure Roll scratched or
dirty and damaged?
TROUBLESHOOTING
Problems
The printed image is not sufficiently fixed to
the paper. The image is easily removed by
rubbing it with your fingers.
ESS and possible parts that caused the error
FUSER ASSY
PWBA ESS
PWBA MCU
Yes No
End of Go to Step [2].
procedure
Go to Step [3]. Adjust the
Transfer
Voltage.
Replace FUSER Go to Step [4].
ASSY. (p.388)
Printing Quality-related Trouble
Step Check
Check after replacement of FUSER ASSY
4
W A R N I N G
Allow FUSER ASSY to cool down
before performing work.
Replace FUSER ASSY. (p.388)
Make a test print of the problem image.
Is the image printed normally?
Check after replacement of PWBA MCU
5
Replace PWBA MCU. (p.404)
Make a test print of the problem image.
Is the image printed normally?
Revision B
Yes No
End of Go to Step [5].
procedure
End of Replace "ESS
procedure and possible
parts that caused
the error".
260