Switch Assy Top - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.2.6 SWITCH ASSY TOP

REMOVAL
1. Remove COVER ASSY RH. (p.301)
2. Unclamp the two clamps fastening the harness of SWITCH ASSY TOP, and
remove the harness.
When performing the following work, leave the intermediate
C A U T I O N
connector (blue) on the harness side.
3. Disconnect connector (P/J116, blue) of SWITCH ASSY TOP.
4. Remove the screw (silver, with flange, 8 mm) fastening SWITCH ASSY TOP to
the main unit.
5. Remove SWITCH ASSY TOP from the main unit.
REINSTALLATION
1. Match the hole on SWITCH ASSY TOP with the boss on the main unit, and
attach.
2. Fasten SWITCH ASSY TOP to the main unit with the screw (silver, with flange, 8
mm).
3. Connect connector (P/J116, blue) of SWITCH ASSY TOP.
4. Clamp the harness of SWITCH ASSY TOP with the two clamps.
5. Attach COVER ASSY RH. (p.301)
DISASSEMBLY AND ASSEMBLY
Intermediate connector
4)
2)
3)
2)
(Blue)
Figure 4-8. Removal of SWITCH ASSY TOP
COVER
Revision B
(blue)
Leg_Sec03_006EB
288