Clutch Assy Pre Regi - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.4.13 CLUTCH ASSY PRE REGI

Step numbers with [ ] in the figure indicate the step of
C A U T I O N
reinstallation.
REMOVAL
1. Remove FRAME ASSY-PH. (p.327)
2. Remove MOTOR-PH. (p.337)
3. Remove DRIVE ASSY-PH. (p.340)
When performing the following work, do not disconnect the relay
C A U T I O N
connectors.
4. Disconnect the connector (P/J202) from CLUTCH ASSY REGI, and remove the
harness of CLUTCH ASSY REGI from the groove on FRAME ASSY-PH.
5. Remove the E-rings fastening CLUTCH ASSY PRE REGI to FRAME ASSY-PH.
6. Remove CLUTCH ASSY PRE REGI from FRAME ASSY-PH, and remove the
harness of CLUTCH ASSY PRE REGI from the hole on FRAME ASSY-PH.
REINSTALLATION
1. Insert the harness of CLUTCH ASSY PRE REGI into the hole on FRAME ASSY-
PH.
2. Match the hole position of CLUTCH ASSY PRE REGI with the D cut surface on
the shaft of ROLL ASSY-PRE REGI, and attach CLUTCH ASSY PRE REGI so
that the protrusion on FRAME ASSY-PH enters the concave portion on CLUTCH
ASSY PRE REGI.
3. Fasten CLUTCH ASSY PRE REGI to FRAME ASSY-PH with an E-ring.
DISASSEMBLY AND ASSEMBLY
4. Route the harness of CLUTCH ASSY PRE REGI in the groove on FRAME
ASSY-PH, and connect the connector (P/J202) to CLUTCH ASSY PRE REGI.
5. Attach DRIVE ASSY-PH.
6. Attach MOTOR-PH. (p.337)
7. Attach FRAME ASSY-PH.
Figure 4-54. Removal of CLUTCH ASSY PRE REGI
PH ASSY
(p.340)
(p.327)
4)
Leg_Sec03_067FA
Revision B
[4)]
6)
5)
338