Epson AcuLaser C1100 Service Manual page 174

EPSON AcuLaser C1100
FIP-31
Panel Message
Jam C, E, F
Jam D, E, F
Possible parts that caused the error
FUSER ASSY
ROLL REGI RUBBER
HARNESS-ASSY P/H1
MOTOR-PH
2ND BTR ASSY
FRAME ASSY BTR
Photoconductor Unit
HARNESS ASSY ADC
CAM ASSY-2ND
HARNESS ASSY MAIN
EXIT SENSOR (Sensor in Fuser)
LV/HVPS
Troubleshooting
Step Check
Check of the paper
1
Is the paper loaded in the paper tray wrinkled
or torn?
Paper size setting check
2
Does the size of the paper in use match the
size of the paper set on the control panel?
Does the error recur when a test print is
3
made?
TROUBLESHOOTING
ROLL-REGI METAL
CLUTCH ASSY REGI
HARNESS-ASSY P/H2
PWBA MCU
SHAFT-CENT 2ND
BEARING-BRUSH CAM
SENSOR FUSER IN
HARNESS ASSY 2BTR SENS
SENSOR 2BTR RETRACT
MOT ASSY MICRO
MOT ASSY FSR
HARNESS ASSY MCU C/L
Yes No
Replace with Go to Step [2].
new, dry paper.
Go to Step [4]. Change the
paper size
setting, and
proceed to step
[3].
Go to Step [4]. End of
procedure
FIP according to the printer message
Step Check
Paper check at Gate section inside FUSER
4
ASSY
W A R N I N G
Allow FUSER ASSY to cool down
before performing work.
Remove FUSER ASSY. (p.388)
Is there any paper remaining at the Gate
section inside FUSER ASSY.
Does the error recur when the power is
5
turned ON?
Shape and operation check of ROLL-REGI
6
METAL
Open CHUTE ASSY-REAR.
Is ROLL REGI RUBBER attached correctly?
Also, do these parts rotate smoothly without
any dirt or damage?
Turn by hand to check.
Does the error recur when a test print is
7
made?
Check of paper position
8
Is the leading edge of the paper stopping
before REGI-ROLL?
Check of paper position
9
Has the leading edge of the paper passed
through REGI-ROLL, and stopped before
Fuser Roll inside FUSER ASSY?
Operation check of CLUTCH ASSY REGI
10
Does CLUTCH ASSY REGI operate
normally?
Make a test print and confirm by the operating
noise.
Revision B
Yes No
Remove the Go to Step [6].
remaining paper
and proceed to
step [5].
Go to Step[6]. End of
procedure
Go to Step [7]. Replace ROLL
in question.
Go to Step [8]. End of
procedure
Go to Step [10]. Go to Step [9].
Go to Step [17]. Go to Step [30].
Go to Step [14]. Go to Step [11].
174