Mot Assy Mag - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.10.4 MOT ASSY MAG

REMOVAL
1. Remove COVER ASSY LH. (p.295)
When performing the following work, the connector of PWBA ESS
C H E C K
P O I N T
does not need to be removed.
2. Remove CHASSIS ASSY ESS.
3. Disconnect connector (P/J405) and connector (P/J406) from PWBA MCU.
4. Remove the 3 screws (silver, with flange, 10 mm) fastening MOT ASSY MAG to
the main unit.
5. Remove MOT ASSY MAG from the main unit.
REINSTALLATION
1. Match the boss on MOT ASSY MAG with the hole on the main unit, and attach.
2. Fasten MOT ASSY MAG to the main unit with the 3 screws (silver, with flange,
10 mm).
3. Connect connector (P/J405) and connector (P/J406) to PWBA MCU.
4. Attach CHASSIS ASSY ESS. (p.411)
5. Attach COVER ASSY LH. (p.295)
Table 4-5. Symptoms when the connector is loose
Connector
Panel Indication Symptom
No.
Printed light and
P/J405 ---
faint
P/J406 --- Normal printing
DISASSEMBLY AND ASSEMBLY
(p.411)
Error Caused by Connector
Disconnection
---
---
4)
4)
4)
Figure 4-102. Removal of MOT ASSY MAG
DRIVE
3)
3)
5)
Revision B
Leg_Sec03_102FA
396