Epson AcuLaser C1100 Service Manual page 7

High Temperature Assembly
When working with hot parts (FUSER etc.) make sure to turn the power off, unplug the
power cable, and leave the printer until it cools down sufficiently to work with to
prevent burn injury.
W A R N I N G
As the inside of the printer is high-temperature state immediately
after the operation, leave it more than 30 minutes before working.
Caution Label
(Refer to "Caution Label About High-temperature
DUPLEX ASSY
Caution Label
(Refer to "Caution Label About High-temperature
FUSER ASSY
Surface")
Surface")
Leg_Sec001_022EA