Epson AcuLaser C1100 Service Manual page 418

EPSON AcuLaser C1100
REINSTALLATION
1. Match each of the bosses and holes on INVERTER ASSY DUP with
TRANSPORT ASSY DUP, and attach INVERTER ASSY DUP to TRANSPORT
ASSY DUP.
2. Attach INVERTER ASSY DUP to TRANSPORT ASSY DUP with the 2 screws
(silver, with flange, tapping, 10mm).
3. Connect connector (P/J444) to PWBA DUP-L.
4. Route the harness, and fasten the harness by the clamp on BKT MOTOR DUP
TRANS.
5. Pass the harness through the hole on DUPLEX ASSY, and connect connector (P/
J122) to SWITCH-DUP DOOR.
6. Match the 2 hooks on the rear of COVER REAR with DUPLEX ASSY, and attach
COVER REAR.
7. Fasten COVER REAR to DUPLEX ASSY with the screw (silver, with flange,
tapping, 10 mm).
8. Attach COVER UP-DUP TRANS.
9. Attach COVER LOW-DUP TRANS.
10. Attach LINK-LATCH and LINK-BUTTON.
11. Attach COVER-L DUP. (p.414)
12. Attach COVER-R DUP. (p.413)
13. Attach DUPLEX ASSY. (p.412)
DISASSEMBLY AND ASSEMBLY
(p.437)
(p.436)
(p.416)
DUPLEX
Revision B
418