Fabric Feed Adjustment (Manual) - Epson ML-13000 User Manual

ML-13000 User's Manual
J
On the entry screen of each block, set the number confirmed in Step 4 by touching
OK.
The Fabric Settings menu is displayed when you finish the adjustments.

Fabric Feed Adjustment (Manual)

Manually adjust the fabric feed.
A
Check that the printer is ready, and load the fabric according to the actual usage conditions.
B
From the menu button on the control panel, touch General Settings - Printer Settings to set the Print
Width and Print Start Position.
C
Touch Fabric Settings - Print Adjustments - Fabric Feed Adjustment - Manual, in that order.
D
Touch Start.
An adjustment pattern is printed. Wait until adjustment is complete.
E
Open the front cover to check the printed adjustment pattern.
Select the pattern with the least amount of overlapping or gaps. Select "-0.1%" in the example shown below.
If there are patterns where the overlapping or gaps are the same, enter the middle value in Step 6. Enter
"-0.15%" in the example shown below.
If all of the adjustment patterns contain overlaps or gaps, and you cannot narrow it down to 1, select the
pattern with the least overlaps and gaps. Do Steps 2 to 5 again, and repeat them until a pattern with no
overlaps or gaps is printed.
Basic Operations
138
/ , and then touch