Epson AcuLaser C1100 Service Manual page 305

EPSON AcuLaser C1100
REINSTALLATION
When performing the following work, take care to prevent the
C A U T I O N
cable tie that bundles the harness of HARNESS-ASSY P/H 1
from being caught on the holes, etc. on the main unit.
When performing the following work, take care to prevent the
HARNESS-ASSY P/H 1 from being sandwiched between the
main unit and MSI ASSY.
1. Gently insert HARNESS-ASSY P/H 1 along the left side of MSI ASSY together
with MSI ASSY from the front of the main unit.
2. Insert MSI ASSY about halfway with the front of MSI ASSY lifted slightly to
avoid TIE PLATE under the main unit, and then bring out the connector of
HARNESS-ASSY P/H 1 from the hole on the main unit.
3. After matching MSI ASSY to the main unit attachment position, gently pull
HARNESS-ASSY P/H 1 from the outside to take up any slack inside the main
unit.
4. Fasten MSI ASSY to the main unit with the 6 screws (silver, with flange, tapping,
8 mm).
5. Connect connector (P/J408) and connector (P/J409) to PWBA MCU.
6. Fasten the harness of HARNESS-ASSY P/H 1 with the two clamps on CHASSIS
ESS.
7. Attach FRAME ASSY-PH. (p.327)
8. Attach COVER FRONT L and COVER FRONT ASSY U.
9. Attach COVER MSI. (p.291)
10. Attach COVER ASSY LH. (p.295)
11. Attach COVER ASSY RH. (p.301)
Table 4-2. Symptoms when the connector is loose
Connector
Panel Indication Symptom
No.
Printing is not
P/J408 E Open
possible.
Printing is not
P/J409 Service Req E511
possible.
DISASSEMBLY AND ASSEMBLY
(p.292)
Error Caused by Connector
Disconnection
Paper Feeder Rear Cover is open.
Sensor TR0 error
[2)-2]
[3)]
CAUTION
Figure 4-24. Reinstallation of MSI ASSY
MSI
Revision B
1
[2)-1]
[1)]
Leg_Sec03_507EB
305