Holder-Adc 2Nd - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.5.8 HOLDER-ADC 2ND

Step numbers with [ ] in the figure indicate the step of
C A U T I O N
reinstallation.
REMOVAL
1. Remove COVER ASSY RH. (p.301)
2. Remove CHUTE ASSY-FSR and COVER ASSY-RR 2ND.
3. Remove 2ND BTR ASSY. (p.348)
4. Remove PLATE BIAS-2ND. (p.358)
5. Remove SENSOR 2BTR RETRACT.
6. Remove CAM ASSY-2ND. (p.350)
7. Remove SPRING-2ND fastening both ends of FRAME ASSY-2ND to the main
unit. (p.346)
8. Remove FUSER ASSY. (p.388)
9. Disconnect connector (P/J431) from SENSOR ASSY ADC.
10. Remove the 2 screws (silver, with flange, 8 mm) fastening HOLDER-ADC 2ND
to the main unit.
11. Remove HOLDER-ADC 2ND from the main unit together with SENSOR ASSY
ADC.
12. Remove the 2 screws (silver, with washer, tapping, 8 mm) fastening SENSOR
ASSY ADC to HOLDER-ADC 2ND.
13. Remove SENSOR ASSY ADC from HOLDER-ADC 2ND.
DISASSEMBLY AND ASSEMBLY
(p.341)
(p.356)
Figure 4-67. Removal of HOLDER-ADC 2ND
TRANSFER
13)
12)
12)
10)
10)
9)
[3)]
Leg_Sec03_512EB
Revision B
11)
354