Epson AcuLaser C1100 Service Manual page 444

EPSON AcuLaser C1100
REINSTALLATION
When performing the following work, pay attention to the
C A U T I O N
attachment direction of MOTOR ASSY DUP.
1. Match the harness side of MOTOR ASSY DUP with the
MOTOR DUP TRANS, and attach to MOTOR ASSY DUP.
2. Fasten MOTOR ASSY DUP to BKT MOTOR DUP TRANS with the 4 screws
(silver, 5mm).
3. Connect connector (P/J442) of MOTOR ASSY DUP on PWBA DUP-L, and
fasten the harness on MOTOR ASSY DUP with the clamp.
4. Match the hole on BKT MOTOR DUP TRANS with the shaft on DUPLEX
ASSY, and attach together with PWBA DUP-L and MOTOR ASSY DUP.
5. Fasten BKT MOTOR DUP TRANS to DUPLEX ASSY with the 4 screws (silver,
with flange, tapping, 10mm).
6. Connect connector (P/J444) to PWBA DUP-L.
7. Route the harness, and fasten the harness by the clamp on BKT MOTOR DUP
TRANS.
8. Attach COVER-L DUP. (p.414)
9. Attach DUPLEX ASSY. (p.412)
DISASSEMBLY AND ASSEMBLY
mark on BKT
DUPLEX
8)
8)
8)
8)
7)-1
7)-2
Figure 4-144. Removal of MOTOR ASSY DUP (2)
Revision B
9)
Leg_Sec03_140FB
444