Writing Usb Id - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

5.1.3 Writing USB ID

AcuLaser C1100 is equipped with a USB interface as a standard feature. The PC
connected to the printer via the USB interface identifies the printer by referring to the
USB ID information specific to each printer. This USB ID information is stored on
EEPROM on the controller of the printer. Therefore, you have to rewrite the ID
information by the procedure described below when you have replaced the BOARD
ASSY., MAIN with a new one.
The following are the name of the program to input the ID, and the operating
environment.
Program
PagePrinter_Ver10E.exe
Operating environment
OS:
Windows95 OSR2.0 or later, Windows98, Windows Me
or Windows 2000/XP
Port used:
LPT, USB
ADJUSTMENT
5.1.3.1 Installing the Program and the Basic Operation
1. Copy a set of files related to USB-ID input program into a folder.
Be sure to store the setting information file (Setting.ini) in the same
C A U T I O N
drive holder where the main program file is stored.
2. Double-click the program icon [
3. Select "AL-C1100" at the [Model Name].
4. Select the port used to connect the printer at the [Interface].
If you select "Auto", connected printers are detected and
C H E C K
P O I N T
communication with the first detected one start automatically.
When connecting with 2 or more printers, specify the target port to
avoid unexpected connection since the auto detection varies
depending on the connection state.
Overview
] to start the program.
Figure 5-1. Basic Operation
Revision B
487