Life Details - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

1.13 Life details

Monochrome mode
Table 1-33. Monochrome mode
Catalog
Area
Unit specification
Coverage
value
5%
Monochrome
Continuation
Photoconductor 42,000page
10%
1
Unit*
14,000page
2p/J
B:C=1:2
20%
4,000 5%
Toner Cartridge
1,500 5%
2
FUSER ASSY* 100,000 ---
HOUSING
100,000 ---
ASSY-DEVE K
2ND BTR
100,000 ---
ASSY
Note : B:Monochrome C:Color
Note *1: 1. The life of a Photoconductor Unit may not reach the above numerical
value according to an operating condition.
It becomes a life end by full of the waste toner. (Because waste toner box is
included in a unit.)
The following are main factors to decrease the life.
When area coverage exceeds about 10%
When the power has been switched frequently
Printing on special paper (Thick paper, Envelope, Transparencies)
2. The calculation for the life of Photoconductor is based on the following
conditions.
Power-source ON/OFF is not considered.
Calibration: 1 time /20pages
Jam recovery operation at the time of Jam is included.
*2: The life may become below half if the user print on envelopes or thick paper
frequently.
(Excessive pressure is applied to a heat roll and wrinkles papers on the roll.)
PRODUCT DESCRIPTION
LIFE (unit: pages)
Printing
Continuous
speed mode
4p/J
printing
Standard 42,000 39,400
Low speed 12,500 11,500
Standard 42,000 38,500
Low speed 12,500 11,500
Standard 31,000 31,000
Low speed 12,400 11,500
--- 4,000 4,000
--- 1,500 1,500
100,000
Standard 100,000
(TBD)
--- 100,000 100,000
--- 100,000 100,000
Color mode
Catalog
Unit specification
value
Color
1p/J
Continuation
20,900
10,500page
Photoconductor
1
9,200 Unit*
14,000page
2p/J
20,500
B:C=1:2
9,200
20,000
4,000
Toner Cartridge
9,100
1,500
4,000
2 100,000
FUSER ASSY*
1,500
HOUSING
(TBD)
ASSY-DEVE 100,000
Y/M/C
100,000
2ND BTR
100,000
ASSY
100,000
Note : B:Monochrome C:Color
Note *1: 1. The life of a Photo Conductor unit may not reach the above numerical
value according to an operating condition.
It becomes a life end by full of the waste toner. (Because waste toner box is
included in a unit.)
The following are main factors to decrease the life.
When area coverage exceeds about 10%
When the power has been switched frequently
Printing on special paper (Thick paper, Envelope, Transparencies)
2. The calculation for the life of Photoconductor is based on the following
conditions.
Power-source ON/OFF is not considered.
Calibration: 1 time /20pages
Jam recovery operation at the time of Jam is included.
*2: The life may become below half if the user print on envelopes or thick paper
frequently.
(Excessive pressure is applied to a heat roll and wrinkles papers on the roll.)
Life details
Table 1-34. Color mode
LIFE (unit: pages)
Area Printing
Continuous
Coverage speed mode
printing
Standard 10,500
5%
Low speed 7,900
Standard 10,500
10%
Low speed 7,800
Standard 5,300
20%
Low speed 5,300
5% --- 4,000
5% --- 1,500
--- Standard 100,000
--- --- 66,700
--- --- 100,000
Revision B
4p/J 1p/J
10,500 10,500
7,500 6,400
10,500 10,300
7,400 6,300
5,300 5,300
5,300 5,300
4,000 4,000
1,500 1,500
100,000
(TBD)
(TBD)
66,700 66,700
100,000 100,000
45