Drive Assy Feed - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.13.12 DRIVE ASSY FEED

REMOVAL
1. Remove COVER LEFT 500. (p.453)
2. Remove CLUTCH ASSY FEED.
When performing the following work, leave the intermediate
C A U T I O N
connector of the connector (P/J610) on SOLENOID FEED on the
harness side.
3. Disconnect connector (P/J446) from PWBA MOT and connector (P/J610) from
SOLENOID FEED.
The screws to be removed in the following work are those fastening
C A U T I O N
the four corners (marked by
screws must not be removed.
4. Remove the 4 screws (silver, 6 mm) fastening DRIVE ASSY FEED to 500
PAPER FEEDER ASSY.
5. Remove the protrusion on the top right of DRIVE ASSY FEED from 500 PAPER
FEEDER ASSY, and remove DRIVE ASSY FEED.
REINSTALLATION
1. Hook the protrusion on the top right of DRIVE ASSY FEED onto the notch on
500 PAPER FEEDER ASSY, and match the hole on DRIVE ASSY FEED with
the boss on 500 PAPER FEEDER ASSY to attach.
2. Fasten DRIVE ASSY FEED to 500 PAPER FEEDER ASSY with the 4 screws
(silver, 6 mm).
3. Connect connector (P/J446) to PWBA MOT and connector (P/J610) to
SOLENOID FEED.
4. Attach CLUTCH ASSY FEED.
5. Attach COVER LEFT 500. (p.453)
DISASSEMBLY AND ASSEMBLY
(p.461)
) on DRIVE ASSY FEED. Other
(p.461)
500 PAPER CASSETTE & 500 PAPER FEEDER
5)-1
4)
4)
4)
5)-2
4)
CAUTION
Figure 4-158. Removal of DRIVE ASSY FEED
Table 4-14. Symptoms when the connector is loose
Connector
Panel Indication Symptom
No.
P/J446 Jam LC, G FEEDER Jam
Printing is not
P/J610 Paper Out LC1
possible.
Revision B
3)
Leg_Sec03_023EA
Error Caused by Connector
Disconnection
---
No paper in Paper Cassette
458