Entry Into Maintenance Mode - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

6.3.2 Entry into Maintenance Mode

1. While holding down the [Back], [Up], [Down] and [Enter] buttons, turn the printer
on.
When the printer is turned on, all LEDs and LCD light and the following message
is then displayed.
(When "MAINTENANCE MODE" appears, release your hand from the
switches.)
RAM CHECK **.*MB MAINTENANCE MODE
2. Refer to the Maintenance Menu process flowchart in Figure6-2, perform each
function of the Maintenance Menu by operating the panel switches.
NOTE 1: Disconnect all the Interface Cables in advance.
2: Engine-related service call errors are ignored when the Maintenance
Mode starts. Before starting the printer in the Maintenance Mode and
executing printing, make sure that no errors have occurred in the normal
operating mode.
3: To exit from the Maintenance Menu, make sure that the engine is not
operating and then turn the printer off.
MAINTENANCE
Maintenance Menu
Information Menu
Ready
Ready
Maintenance Menu
[Enter] SW
A
Engine Status Sheet
[Up] SW
Print Log Report
[Up] SW
Reset 2ndBTRCounter
Reset C DvlpCounter
Reset M DvlpCounter
Reset Y DvlpCounter
Reset K DvlpCounter
Reset Fuser Counter
Clear Error Log
MCU DATA BackUp
MCU DATA Restore
A
Figure 6-2. Maintenance Menu Process Flowchart
Revision B
[Enter] SW
Print execution
[Down] SW
Print execution
Clear execution
Clear execution
Clear execution
Clear execution
Clear execution
Clear execution
Clear execution
Command
execution
Command
execution
498