External Interface Specifications - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

1.14.3 External Interface Specifications

The printer provides the following host interfaces.
Parallel (IEEE1284 compliant) interface: Standard
USB (Rev.2.0 HS) interface
Network interface
The locations of the respective interfaces are shown below.
Parallel interface
(IEEE1284 B-type)
Network interface (option)
USB interface
Figure 1-13. Location of external interfaces
PARALLEL INTERFACE SPECIFICATIONS
The Device ID for this printer is as shown below.
MFG EPSON;
CMD : EJL, ESCPAGES-03;
MDL : AL-C1100;
CLS : PRINTER;
DES : EPSON AL-C1100;
PRODUCT DESCRIPTION
: Standard
: Standard or Option
Controller Specifications
USB INTERFACE SPECIFICATIONS
Universal Serial Bus Specification Rev.2.0 HS is supported.
USB model specific number: 31
When the printer is connected to the PC by the USB port, the interface does not support
D4. The D4 protocol become valid only when the EPSON external LAN option is
connected. The device ID CMD differs from the parallel interface, with D4L3 added.
CMD: EJL, ESCPAGES-03; D4L3;
NETWORK INTERFACE SPECIFICATIONS
Printing protocol
TCP/IP
LPR, FTP, IPP, PORT2501, PORT9100
Microsoft Network
SMB
AppleTalk
Management protocol
TCP/IP
SNMP, ENPC, HTTP, TELNET, DHCP, BOOTP, PING, DDNS, mDNS
SNTP
Microsoft Network
Auto-IP, SSDP
MS Network (NetBEUI)
SNMP, ENPC
AppleTalk
SNMP, ENPC
Note *1: mDNS is used with Rendezvous
Entity Type
EPSONPAGES3
Revision B
*1
,
47