Configuring Advanced Ipsec/Ike Parameters; Figure 5-8: Ipsec Table Screen - AudioCodes Mediant 2000 User Manual

5.6

Configuring Advanced IPSec/IKE Parameters

After you have pre-configured IPSec via SSH (refer to ''Securing EMS-Device
Communication'' on page 204), you can optionally configure additional IPSec and IKE
entries for other SNMP Managers aside from the EMS.
Note:

To configure IPSec/IKE tables:
1. In the MG Tree, select the device.
2. On the Tab bar, select General Configuration, and then click Info & Security
'MG Info and Security Provisioning' screen is displayed.
3. Select the
4. Select the
a row is added to the table.
5. Double-click each field to insert required values.
6. Right-click the new entry, and then from the shortcut menu, choose Unlock rows
7. Click Save, and then Close
8. Select the
9. Repeat steps 4 through 7.
SIP User's Manual
Do not remove the default IPSec and IKE tables that were previously loaded
to the device when you enabled IPSec.
IPSec Table tab; the 'IPSec Table' screen is displayed.
button to add a new entry, and then click Yes

Figure 5-8: IPSec Table Screen

.
IKE Table tab; the 'IKE Table' screen appears.
214
Mediant 2000
; the
at the confirmation prompt;
.
Document #: LTRT-68809