SIP User's Manual
3.3.7.10 Trunk Groups
The Trunk Group submenu allows you to configure groups of channels called Trunk
Groups. This submenu includes the following page items:
Trunk Group (refer to "Configuring the Trunk Group Table" on page 155)
Trunk Group Settings (refer to ''Configuring the Trunk Group Settings''
3.3.7.10.1 Configuring the Trunk Group Table
The 'Trunk Group Table' page allows you to enable the device's channels by assigning
them telephone numbers and other attributes (e.g., Trunk Groups and Profiles). Trunk
Groups are used for routing IP-to-Tel calls with common rules. Channels that are not
defined are disabled. You can define up to 24 entries in this table.
Note:
To configure the Trunk
1.
Open the '
menu > Trunk Group submenu > Trunk Group
2.
Configure the Trunk Group according to the table below
3.
Click the
4.
To save the changes to the flash memory, refer to ''
173
.
Version 5.8
You can also configure the Trunk Groups using the ini file table parameter
TrunkGroup_x to (refer to ''Number Manipulation and Routing Parameters''
page
348
).
Group table:
Trunk Group Table' page (Configuration tab > Protocol Configuration
Figure 3-86:
Trunk Group Table Page
Submit
button to save your changes.
page item).
.
Saving Configuration''
155
3. Web-Based Management
on page
157
on page
October 2009
)
on