Trunk Groups Table - AudioCodes Mediant 8000 Installation, Operation & Maintenance Manual

Parameter
Name
IP to IP Enum
Transcoding IfRequired,Force
Mode
41.3

Trunk Groups Table

Use the Trunk Group table to assign trunk groups, profiles and logical telephone
numbers to the gateway's E1/T1 B-channels. Trunk Groups are used for routing IP to
Tel calls with common rules. Channels that are not defined are disabled.
41.3.1 Configuring the Trunk Group Table
This section describes how to configure the trunk group table.

To configure Trunk Group Table:
1.
Click
2.
Select the desired SIP board.
3. In the Navigation pane, select SIP
Group; the SIP Trunk Group list is displayed.
4.
Use the
5. Select a specific row and then in the configuration pane, click SIP Trunk Group
Settings; the SIP Trunk Group Settings screen is displayed.
6.
Configure the Trunk Group parameters according to the table 'Trunk Group
Parameters' below.
7.
Click the Maintenance icon
Installation & Operation Manual
Provisioning
Type
Type
Instant
to access the Media Gateway status screen.
or buttons to add or remove entries correspondingly.
650
Description
Defines the voice transcoding mode
(media negotiation) between two user
agents for the IP-to-IP application.

[0] Only if Required = Do not force.
Media settings (such as gain control)
are not implemented on the voice
stream; the device passes packets
RTP to RTP without any processing.

[1] Force = Force transcoding on
outgoing IP leg. The device
interworks the media by
implementing DSP transcoding
(default).
GW/IP to IP Trunk Groups
and select Unlock to activate the configuration.
Mediant 8000
Trunk
Document # LTRT-92224