Configuring The Qos Settings; Figure 3-41: Qos Settings Page - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
Parameter
Metric
[RoutingTableHopsCountColumn]
Interface
[RoutingTableInterfacesColumn]
3.4.1.6

Configuring the QoS Settings

The 'QoS Settings' page is used for configuring the Quality of Service (QoS) parameters.
This page allows you to assign VLAN priorities (IEEE 802.1p) and Differentiated Services
(DiffServ) for the supported Class of Service (CoS).
To configure QoS, take these 4 steps:
Open the 'QoS Settings' page (Configuration tab > Network Settings menu > QoS
1.
Settings page item).
Configure the QoS parameters according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
4.
Version 5.6
Multiple Interface Table'' on page 55).
The maximum number of allowed routers (hops)
between the device and destination.
Note: This parameter must be set to 1 for the routing
rule to be valid. Routing entries with Hop Count equals
0 are local routes set automatically by the device.
Specifies the interface (network type) to which the
routing rule is applied.
[0] = OAMP (default).
[1] = Media.
[2] = Control.
For detailed information on the network types, refer to
''Configuring the Multiple Interface Table'' on page 55.

Figure 3-41: QoS Settings Page

65
3. Web-Based Management
Description
November 2008