Radius Parameters - AudioCodes Mediant 1000B User Manual

Parameter
> use-local-users-db
[MgmtUseLocalUsersDatabase]
Behavior upon Authentication
Server Timeout
configure system > mgmt-auth
> timeout-behavior
[MgmtBehaviorOnTimeout]
Default Access Level
configure system > mgmt-auth
> default-access-level
[DefaultAccessLevel]
65.13.1.2

RADIUS Parameters

The RADIUS parameters are described in the table below.
Parameter
General RADIUS Parameters
Enable RADIUS Access
Control
configure system > radius
settings > enable
[EnableRADIUS]
[RadiusTrafficType]
User's Manual
(username-password) of users when logging into the device's
management interface (e.g., Web or CLI).

[0] When No Auth Server Defined = (Default) The device
authenticates the users using the Local Users table in the
following scenarios:

If no LDAP/RADIUS server is configured.

If an LDAP/RADIUS server is configured, but connectivity
with the server is down. If there is connectivity with the
server, the device uses the server to authenticate the user.

[1] Always = The device first attempts to authenticate the user
using the Local Users table. If no user is found (based on the
username-password combination), it attempts to authenticate
the user using the LDAP/RADIUS server.
Defines the device's response when a connection timeout occurs
with the LDAP/RADIUS server.

[0] Deny Access = User is denied access to the management
platform.

[1] Verify Access Locally = (Default) Device verifies the user's
credentials in its Local Users table (local database).
Note: The parameter is applicable to LDAP- and RADIUS-based
management-user login authentication.
Defines the default access level for the device when the
LDAP/RADIUS response doesn't include an access level attribute
for determining the user's management access level.
The valid range is 0 to 255. The default is 200 (i.e., Security
Administrator).
Note: The parameter is applicable to LDAP- or RADIUS-based
management-user login authentication and authorization.
Table 65-75: RADIUS Parameters
Enables the RADIUS application.

[0] Disable (Default)

[1] Enable
Note: For the parameter to take effect, a device reset is required.
Defines the device's network interface for communicating (RADIUS
traffic) with the RADIUS server(s).

[0] OAMP (default)

[1] Control
Note: If set to Control, only one Control interface must be configured in
1258
Mediant 1000B Gateway & E-SBC
Description
Description
Document #: LTRT-27055