Radius Parameters - AudioCodes Mediant 800 User Manual

CHAPTER 72 Configuration Parameters Reference
'Behavior upon Authentication
Server Timeout'
configure system >
mgmt-auth > timeout-
behavior
[MgmtBehaviorOnTimeout]
'Default Access Level'
configure system >
mgmt-auth > default-
access-level
[DefaultAccessLevel]

RADIUS Parameters

The RADIUS parameters are described in the table below.
Parameter
General RADIUS Parameters
'Enable RADIUS Access
Control'
configure system >
radius settings >
enable
[EnableRADIUS]
[RadiusTrafficType]
Parameter
Table 72-71:RADIUS Parameters
Enables the RADIUS application.
■
■
Note: For the parameter to take effect, a device reset is
required.
Defines the device's network interface for communicating
(RADIUS traffic) with the RADIUS server(s).
■
■
Mediant 800 Gateway & E-SBC | User's Manual
Description
■ If you have not configured an Authentication server,
the device uses the Local Users table to authenticate
the user.
Defines the device's response when a connection timeout
occurs with the LDAP/RADIUS server.
■ [0] Deny Access = User is denied access to the
management platform.
■ [1] Verify Access Locally = (Default) Device verifies
the user's credentials in its Local Users table (local
database).
Note: The parameter is applicable to LDAP- and
RADIUS-based management-user login authentication.
Defines the default access level for the device when the
LDAP/RADIUS response doesn't include an access level
attribute for determining the user's management access
level.
The valid range is 0 to 255. The default is 200 (i.e.,
Security Administrator).
Note:
■ The parameter is applicable to LDAP- and RADIUS-
based management-user login authentication and
authorization.
■ If a user is not associated with any LDAP Group (at
the LDAP server), the device automatically uses the
value of this parameter as the access level.
Description
[0] Disable (default)
[1] Enable
[0] = (Default) OAMP
[1] = Control
- 1432 -