Settings For Dialing; Changing The Dialing Pause Length; Changing Redial Settings - imagistics 5000 Operating Manual

Settings for dialing

Changing the dialing pause length

Default setting: 2 seconds.
The pause is set by the factory to last two seconds, but you can set it to last as long
as ten seconds if necessary. To change the pause length:
1
Press , 2, 2, 0, 5, .
MENU ENTER
05.Dialing Pause 05.Dialing Pause
Pause Time(02-10) : Pause Time(02-10) :02 sec. 2 sec.
2
Use the numeric keypad to enter the length you want for the dialing pause.
Note: The length setting requires two digits. Always enter a leading zero for
lengths less than 10 seconds.
3
Press enter to save the setting.

Changing redial settings

Default setting: Number of redial: 3 times, Redial interval: 1 minute.
It's up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval).
To program the redial settings:
1
Press , 2, 2, 0, 4, .
MENU ENTER
04.Redial
Exit
# of Redials : 3 times
Interval : 1 min.
2
Using the cursor key, select "# of Redials" and then press
04.Redial
# of Redials (00-15): 02 times
3
Use the numeric keypad to enter the number of redials you want, from
2 to 15.
Note: Enter a leading zero when entering a quantity less than 10.
Note: Also you can set the number of redials using
4
When you finished the entering number, press
5
Using the cursor key, select "Interval" and then press
The
04.Redial
Interval (1-5) :
6
Use the numeric keypad to enter the length you want between redial
attempts. Choose from 1 to 5 minutes.
Note: Also you can set the length between redial attempts using
7
When you finished the entering number, press
8
To save the setting, select "Exit" and then press
.
ENTER
will show:
LCD
1 min.
Changing the default settings
or .
.
ENTER
.
ENTER
or .
.
ENTER
.
ENTER
4.5