imagistics 5000 Operating Manual page 20

Setting the Paper Size
Default setting: Letter-sized paper
When you change the size of paper in the paper cassette, you must also change the
paper size setting, as shown below.
1
Press , 2, 1, 0, 1, . The
MENU ENTER
01. Cassette Size 01. Cassette Size
Exit Exit
1st Cassette 1st Cassette :Letter :Letter
Bypass Tray Bypass Tray :Letter :Letter
2
To select the paper size in the 1st cassette, select "1st Cassette" using the
cursor key and then press
ENTER
1st Cassette 1st Cassette
Letter Letter
Legal
H.LTR H.LTR
3
Use or to select the paper size, Letter
then press to save the setting.
ENTER
4
To set the default paper size that is displayed when you set the paper on the
bypass tray, select "Bypass Tray" and then press
Bypass Tray Bypass Tray
Letter Letter OHP OHP
Legal
H.LTR H.LTR
5
Using the cursor key, select the paper size, Letter
OHP, and then press to save the setting.
ENTER
Note: "OHP" (overhead projector transparency) appears only when the
"Bypass Tray" is selected.
6
Select "Exit" and then press
01. Cassette Size 01. Cassette Size
Exit Exit
1st Cassette 1st Cassette :Letter :Letter
Bypass Tray Bypass Tray :Letter :Letter
shows:
LCD
. The will show:
LCD
, Legal or Half-letter , and
. The
ENTER LCD
, Legal , Half-letter
to exit this mode.
ENTER
Loading paper in bypass tray
When you need to use a size of paper not loaded in your machine's paper cassette(s),
or when you want to use a special type of paper (such as transparency film), use the
bypass tray.
1
Open the bypass tray on the right
side of your machine.
2
Pull out the hopper on the bypass
tray and raise the flapper release
lever.
3
Place the paper on the bypass
tray. Adjust the paper guide to fit
the paper and insert the paper
until it comes to a stop.
Then lower the flapper release
will show:
lever.
4
When you load the paper on the bypass tray, the
paper size you've set. (See "Setting of the paper size," left column.)
or
Bypass Tray Bypass Tray
Letter
Legal
H.LTR H.LTR
5
Use the cursor key to select the paper size you set on the bypass tray.
Then press
Note: If you use transparency film, select "OHP".
Note: If you have set Letter
tray, the machine will use them if it runs out of paper in the cassette during
fax reception.
OHP OHP
.
ENTER
, Legal , Half-letter
Getting started
will show the primary
LCD
sized paper in the bypass
1.9