Table of Contents
Advertisement
Getting started
Level one function
Level two function
2. User Settings
2.Fax Settings
3.Copy Settings
1.14
Level three function
Summary of setting
01.Scan Parameters
You can set the following settings for send fax message.
• Primary resolution mode
• Primary contrast mode
• Scanning width limit
02.Print Parameters
You can set the following settings for receive fax message.
• Reduction rate
• Reduction margin
• Half-page reception
03.Number of Rings
Number of rings before your machine answers.
04.Redial
Number of times and interval for automatic fax redialing.
05.Dialing Pause
Dialing pause length.
06.Memory Transmission On/Off setting for Memory transmission.
07.Quick Memory Tx
On/Off setting for Quick Memory transmission.
08.TTI Transmission
On/Off setting for sending your TTI.
09.ECM Mode
On/Off setting for ECM mode.
10.Block Junk Fax
Reject the fax reception from unauthorized incoming faxes.
11.Security Rx
Keep all received fax messages in memory and after print them.
12.Separator Page
Partition each received documents by inserting the separator page. Off
13.Rotate Rx
On/Off setting for Rotate Rx.
14.PIN Mode
Prevent unauthorized long-distance calls.
15.DRD
Set the ring pattern to use with phone company's Distinctive Ring
service.
16.Remote Copy
Transfer the documents you have sent and/or received to other
fax machine automatically.
17.Jobs Hold
Keep the command when the transmission error occurred or
all redial attempts failed.
01.Scan Parameters
You can set the following settings for copying.
• Primary resolution mode
• Primary contrast mode
• Scanning width limit
02.Print Parameters
You can set the following settings for copying.
• Reduction rate
• Reduction margin
• Bypass Tray priority
Default setting
Page
Normal
Normal
4.1
B4
Auto
40 mm
4.3
Off
2 times
4.4
3 times
4.5
1 minute
2 seconds
4.5
On
4.2
On
4.2
On
4.2
On
4.2
Off
3.56
Off
3.52
3.30
Off
4.4
Off
3.54
Off
3.32
Off
3.25
Off
3.25
Fine
Normal
4.6
B4
100%
24 mm
4.7
Off
Advertisement
Table of Contents
