imagistics 5000 Operating Manual page 128

Reception errors
.1.1 The calling fax machine didn't respond to your fax machine. This can hap-
R
pen if someone dials a wrong number or if the remote machine restricts
access through use of a passcode.
.1.2 The two fax machines were incompatible. Your fax machine sends and
R
receives only - Group 3 (see Glossary, page 5.17) fax communication, the
ITU T
industry standard since the early 1980s.
.1.4 Someone pressed at the receiving fax machine.
R STOP
.1.5 The fax machine didn't detect the silence at the end of the call for receiving
R
an .
RCR
.2.3 Poor phone line conditions made fax communication impossible. Call some-
R
one at the remote machine's location.
.3.1 The sending fax machine detected too many errors from the receiving
R
fax machine.
.3.3 The sending fax machine is incompatible or had a document feeder problem
R
during transmission.
.3.4 Poor phone line conditions may have prevented your fax machine from prop-
R
erly printing some or all of the pages it received.
.4.2 Either the line disconnected before transmission or the transmitting fax
R
machine needs maintenance.
.4.4 The fax machine has reached its memory capacity.
R
.5.1, reception failed (perhaps due to line noise).
R ECM
.5.2
R
.8.1 A compatibility error occurred.
R
.8.10 Line noise or other problems prevented line probing.
R
.8.11 The fax machine timed out while waiting for the retrain signal.
R
Transmission errors
.1.1 The remote fax machine didn't respond to your machine. Call someone at the
T
remote machine's location.
.1.2 Your fax machine's page counter detected a possible document feeder error.
T
Carefully put the document back into the feeder and try again.
.1.4 Stop was pressed before the message was sent.
T
.2.1 Either the phone line disconnected during transmission or fax communica-
T
tion became impossible due to bad phone line conditions. Try the call again.
.2.2 The two fax machines were incompatible. Your fax machine sends and
T
receives only - Group 3 (see "Glossary," page 5.17) fax communication,
ITU T
the industry standard since the early 1980s.
.2.3 Bad phone line conditions made fax communication impossible. Conditions
T
can change rapidly, so try the call again later.
.3.1 The page counter in your fax machine detected a document feeder error dur-
T
ing transmission. Carefully re-insert the document into the feeder and re-try
the call.
.3.2 The fax machine didn't detect a silence indicating the call had ended.
T
.4.1 The telephone line disconnected during transmission because of excessive
T
modem errors or because remote unit ran out of paper. Try the call again.
.4.2 After transmission began, poor line conditions developed. Try the call again.
T
.4.4 Poor line conditions prevented transmission. Try the call again.
T
.5.1, transmission failed (perhaps due to line noise). Conditions can change
T ECM
.5.2, rapidly, so try the call again later.
T
.5.3
T
.8.1 A compatibility error occurred.
T
.8.10 Line noise or other problems prevented line probing.
T
.8.11 The remote fax machine didn't complete equalizer training phase.
T
Just in case ...
5.9