imagistics 5000 Operating Manual page 90

F-Code polling
1
Press . . The
COMM OPTIONS LCD
Communication Options Communication Options
Delayed Transmit Delayed Transmit
Polling Polling
Batch Transmit Batch Transmit
2
Using the cursor key, select "F-Code Polling" and press
shows:
F-Code Polling F-Code Polling
Enter Sub-address Enter Sub-address
_
3
Use the numeric keypad to enter the appropriate sub-address.
Note: If you make a mistake, press
enter the correct number.
4
Press . The shows:
ENTER LCD
F-Code Polling F-Code Polling
Enter Password Enter Password
_
Note: If this sub-address does not have a password, skip to step 7.
5
Use the numeric keypad to enter the password.
6
Press . The shows:
ENTER LCD
Enter Fax Number Enter Fax Number
_
7
Enter the fax number either by pressing a one-touch key, entering a speed-
dial number or dialing from the numeric keypad. Do not press
8
What you do now depends on when you want the polling to begin.
• To have it begin now, skip to step 12.
• To delay it, go on to step 10.
shows:
. The
ENTER
to erase the character, then
CANCEL
START
9
Press .
COMM
Delayed Transmit Delayed Transmit
Enter Transmit Time Enter Transmit Time
--/--:--
10
Use the numeric keypad to enter the day and time when the polling should
begin, then press
LCD
11
Press .
START
If in step 9 you chose an immediate polling, your fax machine begins dialing. If you
chose a delayed command, the machine shows "Reserved" on the
it has stored the command in memory and will complete it later.
.
, . The shows:
OPTIONS ENTER LCD
[ Clear ] [ Clear ]
.
ENTER
Basic operation
, indicating that
LCD
3.43