imagistics 5000 Operating Manual page 126

What you see on the
LCD
Not Allowed in Macro
Open Top Cover
Please Remove Paper
Open 1st Side Cover
Please Remove Paper
Open 2nd Side Cover
Please Remove Paper
Open Top/2-Bin Cover
Please Remove Paper
Remove Bypass Paper
Open&Close Top Cover
PIN is not Stored
Please Call Service
Please Wait
Printer in Use
Replace Drum : Unable to Print The drum unit is at the end of life or damaged.
What it means/What to do
During macro registration, you pressed the key
which cannot be registered in Macro, such as
Monitor/Call key or Security Reception key.
Paper is jammed in your fax machine.
Open the cover indicated on the LCD, and care-
fully remove the jammed paper.
You selected "Mode1" in the mask feature
PIN
and tried to call an autodialer number in which
no PIN has been entered, or call using numeric
keypad without . Enter a , then try again.
PIN PIN
The printer unit of your fax machine has become
inoperable. Call the Imagistics Diagnostic Center.
Your fax machine's printer is either warming up
or busy. Please wait until the fax is finished
printing and then re-try your command or opera-
tion.
The command you're trying to enter requires the
use of the printer, which is already in use. Wait
for the fax to finish printing, then try again.
Your machine cannot print until drum unit is
replaced.
What you see on the
LCD
Replace Drum in 500 Prints
Replace Toner : Unable to Print Your toner cartridge is empty.
Scanner in Use
Security Rx is Off
Select Group Number (0-32)
Toner Low : 50 Prints Remain Your machine is almost out of toner. About 50
Too Many Characters
What it means/What to do
Your machine can print about 500 more sheets,
but your drum will need to be replaced soon.
Please contact the Imagistics Line to purchase
a new drum unit if you don't already have one.
In the USA call for supplies: 1-800-462-6797
Replace the toner cartridge. Your machine cannot
print until it is replaced.
The command you're trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then re-try the
desired command.
You tried to turn security reception
Soft key assigned to security reception, but the
security reception setting feature is set to off.
To turn on or off the security reception using a
Soft key, first set the security reception setting to
on. (See pages 3.52–3.53.)
You tried to enter a call group number greater
than 32. Your machine can maintain 32 call
groups, numbered 1-32 (call group 0 covers all
the groups). Determine the correct call group
identifier number and enter it, instead.
more sheets can be printed, but please contact
the Imagistics Supply Line soon to purchase
a new toner cartridge if you don't already have
one.
In the USA call for supplies: 1-800-462-6797
You attempted to enter too many numbers or
other characters in the current operation.
Press to delete extra characters, then try
CANCEL
again.
Just in case ...
using the
ON
5.7