imagistics 5000 Operating Manual page 66

4
The shows:
LCD
Macros
Overwrite?
[ Yes ] [ No
If you want to overwrite the operation already programmed, press [Yes].
If you want to overwrite only the job's name, press [No] and go to step 9.
If you do not want to overwrite the key you have choice, press
5
The standby LCD display appears and the machine begins to beep which indi-
cates the machine is in the programming mode.
Ready to Fax Ready to Fax
Sep 27 2001 11:30am Mem:100% Sep 27 2001 11:30am Mem:100%
Normal Normal Normal Normal
[ Mode ] [Contrast] [ Mode ] [Contrast]
6
Press the keys exactly as though you were programming a current job. The
machine will beep during programming to confirm MACRO programming mode.
Note: You can program up to 60 steps. If you attempt to set over 60 steps,
your fax machine asks if you want to accept the operations you have
entered. If you want to register them, press
Note: If you want to delete the operations you have set, press
, and then go back to step 1.
MACRO PROGRAM STOP
Example 1: To program copy operations: Press
mode, and set number of the copies, contrast, resolution and reduction rate as
you want.
Note: See "Making copies" (pages 2.9–2.10) for detail operations.
Example 2: To program operations for printing the one-touch numbers list:
Press , 5, 1, 0, 5, .
MENU ENTER
7
If you programmed or
ENTER START
Otherwise, press
MACRO PROGRAM
]
.
STOP
. If not, press
ENTER
to change to the copy
COPY
into the operation, proceed to step 8.
and skip to step 9.
8
If you want to start immediately after pressing the Macro key when you use
it, press [Yes]. If not, press [No].
Note: If you want to confirm the settings or operations in the Macro key
before you start it, press [No] here.
Macros Macros
Include START/ENTER? Include START/ENTER?
[ [
9
The now shows:
LCD
Macros Macros
Title
_
The machine now asks you to enter the title of this job.
If you do not want to enter or change it, skip to step 11.
10
Enter the title by using the numeric keypad. (If necessary, review "Entering
characters", page 1.12) It may be up to 130 characters in length.
11
Press to save the setting.
ENTER
.
STOP
Changing the title of the Macro key
When you want to change only the title of a Macro key:
1
Press
MACRO PROGRAM
Macros Macros
Enter Macros Enter Macros
Erase Macros Erase Macros
Macro Speed Macro Speed
2
Select "Change title" using the cursor key and press
Macros Macros
M01: Trumbull M01: Trumbull
M02: Copy 1 M02: Copy 1
M03: Not stored M03: Not stored
Yes Yes ] [ ] [ No No ] ]
Lower Case Lower Case
. The shows:
LCD
Change Title Change Title
Basic operation
. The shows:
ENTER LCD
3.19