Configuring The Maximum Mac Addresses Per Port; Configuring A Mac-Based Vlan For A Static Host - Dell PowerConnect B-FCXs Configuration Manual

Powerconnect b-series fcx
Hide thumbs Also See for PowerConnect B-FCXs:
Table of Contents

Advertisement

PowerConnect(config)#interface e 3/1
PowerConnect(config-if-e1000-3/1)#mac-authentication disable-aging
Syntax: [no] mac-authentication disable-aging

Configuring the maximum MAC addresses per port

To configure the maximum number of MAC addresses allowed per port, use the following
commands:
NOTE
32 MAC addresses maximum are allowed per port. This total includes both static and dynamic hosts.
The default number of allowed MACs is 2.
NOTE
To change the maximum MAC addresses per port, you must first disable MAC-based VLAN on that
port.

Configuring a MAC-based VLAN for a static host

Follow the steps given below to configure a MAC-based VLAN for a static host.
1. Enable multi-device port authentication globally using the following command.
2. Add each port on which you want MAC-based VLAN enabled as mac-vlan-permit for a specific
3. Add the static MAC-based VLAN configuration on the port.
4. To enable MAC-based VLAN on the port.
5. To disable MAC-based VLAN on the port.
6. To remove and disable the MAC-based VLAN configuration.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
PowerConnect(config)#interface e 0/1/1
PowerConnect(config-if-e1000-0/1/1)#mac-authentication mac-vlan
max-mac-entries 24
PowerConnect(config)#mac-authentication enable
VLAN.
PowerConnect(config)#vlan 10 by port
PowerConnect(config-vlan-10)#mac-vlan-permit ethernet 0/1/1 to 0/1/6
added mac-vlan-permit ports ethe 0/1/1 to 0/1/6 to port-vlan 10.
PowerConnect(config)#interface e 0/1/1
PowerConnect(config-if-e1000-0/1/1)#mac-authentication mac-vlan
0000.0010.0011 vlan 10 priority 5
PowerConnect(config)#interface e 0/1/1
PowerConnect(config-if-e1000-0/1/1)#mac-authentication mac-vlan enable
PowerConnect(config)#interface e 0/1/1
PowerConnect(interface-0/1/1)#mac-auth mac-vlan disable
PowerConnect(config)#interface e 0/1/1
PowerConnect(config-if-e1000-0/1/1)#no mac-auth mac-vlan
Configuring MAC-based VLANs
15
535

Advertisement

Table of Contents
loading

Table of Contents