Synchronize Log Messages - Dell Force10 MXL Blade Configuration Manual

Synchronize log messages

You can configure FTOS to filter and consolidate system messages for a specific line by synchronizing the
message output. Only the messages with a severity at or below the set level appear. This feature works on
the terminal and console connections available on the system.
To synchronize log messages, use these commands in the following sequence starting in
CONFIGURATION mode:
Step Command Syntax
1 line {console 0 | vty number [end-number]}
2
logging synchronous [level severity-level |
all] [limit]
To view the logging synchronous configuration, enter the
60
| Management
Command Mode Purpose
CONFIGURATION Enter the LINE mode. Configure the
following parameters for the virtual
terminal lines:
•
•
You can configure multiple virtual
terminals at one time by entering a
and an
LINE Configure a level and set the maximum
number of messages to be printed.
Configure the following optional
parameters:
•
•
show config
number range: zero (0) to 9.
range: 1 to 8.
end-number
end-number.
level
severity-level range: 0 to 7.
Default is 2. Use the all keyword to
include all messages.
limit range: 20 to 300. Default is 20.
command in LINE mode.
number