Default iSCSI Optimization Values
Table 15-1
Table 15-1. iSCSI Optimization: Default Parameters
Parameter
iSCSI Optimization global setting
iSCSI CoS mode (802.1p priority queue
mapping)
iSCSI CoS Packet classification
VLAN priority tag
DSCP
Remark
iSCSI session aging time
iSCSI optimization target ports
iSCSI Optimization Prerequisites
•
iSCSI optimization requires that you enable LLDP on the switch. LLDP is enabled by default (refer to
Link Layer Discovery Protocol
•
iSCSI optimization requires two ingress ACL groups to be configured. iSCSI is allocated two ACL
groups by default (refer to
282
|
iSCSI Optimization
shows the default values for the iSCSI optimization feature.
(LLDP)).
CAM
Enabled
Enabled: dot1p priority 4 without remark setting
iSCSI packets are classified by VLAN instead of by DSCP values.
iSCSI flows are assigned by default to dot1p priority 4 without remark
setting.
None: user-configurable.
Not configured.
10 minutes
iSCSI well-known ports 3260 and 860 are configured as default (with no IP
address or name) but can be removed as any other configured target.
Allocation).
Default Value