Dell Force10 MXL Blade Configuration Manual page 30

Table 2-1. FTOS Command Modes
CLI Command Mode
CONFIGURATION
Note: Access the following modes from CONFIGURATION mode:
10 Gigabit Ethernet
Interface
40 Gigabit Ethernet
Interface
Interface Range
Loopback Interface
Management Ethernet
Interface
Null Interface
Port-channel Interface
VLAN Interface
Monitor Session
STANDARD ACCESS-
LIST
EXTENDED ACCESS-
LIST
IP COMMUNITY-LIST
CONSOLE
VIRTUAL TERMINAL
STANDARD ACCESS-
LIST
EXTENDED ACCESS-
LIST
MULTIPLE
SPANNING TREE
28
| Configuration Fundamentals
Prompt
FTOS(conf)#
#
FTOS(conf-if-te-0/1)
#
FTOS(conf-if-fo-0/33)
#
FTOS(conf-if-range)
#
FTOS(conf-if-lo-0)
#
FTOS(conf-if-ma-0/0)
FTOS(conf-if-nu-0)#
FTOS(conf-if-po-1)#
FTOS(conf-if-vl-1)#
FTOS(conf-mon-sess)
FTOS(conf-std-nacl)#
FTOS(conf-ext-nacl)#
FTOS(conf-community-list)#
FTOS(conf-line-console)#
FTOS(conf-line-vty)#
FTOS(conf-std-macl)#
FTOS(conf-ext-macl)#
FTOS(conf-mstp)#
Access Command
• From EXEC privilege mode, enter the command
.
configure
• From every mode except EXEC and EXEC
Privilege, enter the command
interface
ip access-list standard
ip access-list extended
ip community-list
line
mac access-list standard
mac access-list extended
protocol spanning-tree mstp
.
exit