Port-Based Qos Configurations; Implementation Information - Dell Force10 MXL Blade Configuration Manual

Configuration guide for the mxl 10/40gbe switch io module

Hide thumbs Also See for Force10 MXL Blade:

Table of Contents

Figure 24-1. Dell Force10 QoS Architecture

The Dell Force10 QoS implementation complies with IEEE 802.1p User Priority Bits for QoS Indication.

It also implements these Internet Engineering Task Force (IETF) documents:

RFC 2474, Definition of the Differentiated Services Field (DS Field) in the IPv4 Headers

RFC 2475, An Architecture for Differentiated Services

RFC 2597, Assured Forwarding PHB Group

RFC 2598, An Expedited Forwarding PHB

You cannot configure port-based and policy-based QoS on the same interface.

Port-Based QoS Configurations

You can configure the following QoS features on an interface:

Note: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.

Set dot1p Priorities for Incoming Traffic

Configure Port-based Rate Policing

Configure Port-based Rate Shaping

Quality of Service (QoS) | 417

Show Quick Links

Table of Contents