Dell Force10 MXL Blade Configuration Manual page 236

•
ip mtu
Note:
The MXL Switch supports jumbo frames by default (the default maximum transmission unit [MTU]
is 1554 bytes) You can configure the MTU using the
To view the interface's configuration, enter INTERFACE mode for that interface and use the
command or from EXEC Privilege mode, use the
To add a physical interface to a port channel, use these commands in the following sequence in
INTERFACE mode of a port channel:
Step Command Syntax
1
channel-member interface
2 show config
To view the port channel's status and channel members in a tabular format, use the
port-channel brief
Figure 13-10. show interfaces port-channel brief Command Example
FTOS#show int port brief
Codes: L - LACP Port-channel
LAG Mode
1 L3
FTOS#
234 | Interfaces
(if the interface is on a Jumbo-enabled by default.)
command in EXEC Privilege mode
Status Uptime
down 00:00:00
command from INTERFACE mode.
mtu
show running-config interface interface
Command Mode Purpose
INTERFACE Add the interface to a port channel.
PORT-CHANNEL The
type and slot/port information.
INTERFACE Double check that the interface was added to
PORT-CHANNEL the port channel.
(Figure 13-10).
Ports
Te 0/16 (Down)
command.
variable is the physical interface
interface
show interfaces
show config