Change Ospfv2 Parameters On Interfaces - Dell Force10 MXL Blade Configuration Manual

Figure 20-14 shows the convergence settings when you enable fast-convergence.
settings when you disable fast-convergence. To view these settings, use the
Figure 20-14. show ip ospf process-id (Fast-Convergence Enabled ) Command Example
FTOS(conf-router_ospf-1)#fast-converge 2
FTOS(conf-router_ospf-1)#exit
FTOS(conf)#exit
FTOS#show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 2
Min LSA origination 0 msec, Min LSA arrival 0 msec
Min LSA hold time 0 msec, Max LSA wait time 0 msec
Number of area in this router is 0, normal 0 stub 0 nssa 0
FTOS#
Figure 20-15. show ip ospf process-id (Fast-Convergence Disabled) Command Example
FTOS#(conf-router_ospf-1)#no fast-converge
FTOS#(conf-router_ospf-1)#ex
FTOS#(conf)#ex
FTOS##show ip ospf 1
Routing Process ospf 1 with ID 192.168.67.2
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 0, normal 0 stub 0 nssa 0
FTOS#

Change OSPFv2 Parameters on Interfaces

In FTOS, you can modify the OSPF settings on the interfaces. Some interface parameter values must be
consistent across all interfaces to avoid routing errors. For example, to prevent misconfiguration of OSPF
neighbors, you must set the same time interval for the hello packets on all routers in the OSPF network.
Figure 20-15 shows
command.
show ip ospf
Fast-converge parameter
setting
LSA Parameters
Fast-converge parameter
setting
LSA Parameters
Open Shortest Path First (OSPFv2) | 375