Dell Force10 MXL Blade Configuration Manual page 264

Command Syntax
ip route ip-address mask {ip-address
interface [ip-address]} [distance]
[permanent] [tag tag-value]
You can enter as many static IP addresses as necessary.
To view the configured routes, use the
Figure 14-3. show ip route static Command Example (partial)
FTOS#show ip route static
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
--More--
FTOS installs a next hop that is on the directly connected subnet of the current IP address on the interface
(for example, if interface tengig 0/0 is on 172.31.5.0 subnet, FTOS installs the static route).
FTOS also installs a next hop that is not on the directly connected subnet but which recursively resolves to
a next hop on the interface's configured subnet. For example, if tengig 0/0 has ip address on subnet 2.2.2.0
and if 172.31.5.43 recursively resolves to 2.2.2.0, FTOS installs the static route.
• When an interface goes down, FTOS withdraws the route.
262
| IPv4 Routing
|
Destination Gateway
----------- -------
2.1.2.0/24 Direct, Nu 0
6.1.2.0/24 via 6.1.20.2, Te 5/0
6.1.2.2/32 via 6.1.20.2, Te 5/0
6.1.2.3/32 via 6.1.20.2, Te 5/0
6.1.2.4/32 via 6.1.20.2, Te 5/0
6.1.2.5/32 via 6.1.20.2, Te 5/0
6.1.2.6/32 via 6.1.20.2, Te 5/0
6.1.2.7/32 via 6.1.20.2, Te 5/0
6.1.2.8/32 via 6.1.20.2, Te 5/0
6.1.2.9/32 via 6.1.20.2, Te 5/0
6.1.2.10/32 via 6.1.20.2, Te 5/0
6.1.2.11/32 via 6.1.20.2, Te 5/0
6.1.2.12/32 via 6.1.20.2, Te 5/0
6.1.2.13/32 via 6.1.20.2, Te 5/0
6.1.2.14/32 via 6.1.20.2, Te 5/0
6.1.2.15/32 via 6.1.20.2, Te 5/0
6.1.2.16/32 via 6.1.20.2, Te 5/0
6.1.2.17/32 via 6.1.20.2, Te 5/0
11.1.1.0/24 Direct, Nu 0
Direct, Lo 0
Command Mode Purpose
CONFIGURATION Configure a static IP address. Use the following
required and optional parameters:
•
•
•
•
•
•
command
show ip route static
ip-address : Enter an address in dotted decimal
format (A.B.C.D).
: Enter a mask in slash prefix-length
mask
format (/X).
interface : Enter an interface type followed by
slot/port information.
distance range: 1 to 255 (optional).
permanent: Keep the static route in the routing
table (if option is used) even if the
interface
interface with the route is disabled. (optional)
tag
tag-value range: 1 to 4294967295.
(optional)
(Figure 14-3).
Dist/Metric Last Change
----------- -----------
0/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
1/0 00:02:30
0/0 00:02:30