Enable Ospfv2 Authentication - Dell Force10 MXL Blade Configuration Manual

To view interface configurations, use the
(Figure 20-16). To view the interface status in the OSPF process, use the
EXEC mode.
Figure 20-16. Changing the OSPF Cost Value on an Interface
FTOS(conf-if)#ip ospf cost 45
FTOS(conf-if)#show config
!
interface TenGigabitEthernet 0/0
ip address 10.1.2.100 255.255.255.0
no shutdown
ip ospf cost 45
FTOS(conf-if)#end
FTOS#show ip ospf 34 interface
TenGigabitEthernet 0/0 is up, line protocol is up
Internet Address 10.1.2.100/24, Area 2.2.2.2
Process ID 34, Router ID 10.1.2.100, Network Type BROADCAST,
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 10.1.2.100, Interface address 10.1.2.100
Backup Designated Router (ID) 10.1.2.100, Interface address 0.0.0.0
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:06
Neighbor Count is 0, Adjacent neighbor count is 0
FTOS#

Enable OSPFv2 Authentication

To enable or change various OSPF authentication parameters, use the following commands in
CONFIGURATION INTERFACE mode.:
Command Syntax
ip ospf authentication-key key
ip ospf auth-change-wait-time seconds
command in CONFIGURATION INTERFACE mode
show config
Command Mode
CONFIG-INTERFACE
CONFIG-INTERFACE
show ip ospf interface
The change is made on the
interface and it is reflected in the
OSPF configuration
Cost: 45
Usage
Set the clear text authentication scheme on the
interface. Configure a key
longer than eight characters.
All neighboring routers must share the same
password to exchange OSPF information.
Set the authentication change wait time in
seconds between 0 and 300 for the interface.
This is the amount of time OSPF has available to
change its interface authentication type. During
the auth-change-wait-time, OSPF sends out
packets with both the new and old authentication
schemes. This transmission stops when the
period ends. The default is 0 seconds.
Open Shortest Path First (OSPFv2) | 377
command in
that is a text string no