Dell Force10 MXL Blade Configuration Manual page 56

Figure 4-1. Create a Custom Privilege Level Apply a Privilege Level to a Username
FTOS(conf)#do show run privilege
!
FTOS(conf)#privilege exec level 3 capture
FTOS(conf)#privilege exec level 3 configure
FTOS(conf)#privilege exec level 4 resequence
FTOS(conf)#privilege exec level 3 clear arp-cache
FTOS(conf)#privilege exec level 3 clear arp-cache max-buffer-size
FTOS(conf)#privilege configure level 3 line
FTOS(conf)#privilege configure level 3 interface
FTOS(conf)#do telnet 10.11.80.201
[telnet output omitted]
FTOS#show priv
Current privilege level is 3.
FTOS#?
capture
configure
disable
enable
exit
ip
monitor
mtrace
ping
quit
show
[output omitted]
FTOS#config
[output omitted]
FTOS(conf)#do show priv
Current privilege level is 3.
FTOS(conf)#?
end
exit
interface
FTOS(conf)#interface ?
loopback
managementethernet
null
port-channel
range
tengigabitethernet
vlan
FTOS(conf)#interface tengigabitethernet 1/1
FTOS(conf-if-te-1/1)#?
end
exit
FTOS(conf-if-te-1/1)#exit
FTOS(conf)#line ?
console
vty
FTOS(conf)#line vty 0
FTOS(conf-line-vty)#?
exit
FTOS(conf-line-vty)#
54
| Management
Capture packet
Configuring from terminal
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Global IP subcommands
Monitoring feature
Trace reverse multicast path from destination to source
Send echo messages
Exit from the EXEC
Show running system information
Exit from configuration mode
Exit from configuration mode
Select an interface to configure
Loopback interface
Management Ethernet interface
Null interface
Port-channel interface
Configure interface range
TenGigabit Ethernet interface
VLAN interface
Exit from configuration mode
Exit from interface configuration mode
Primary terminal line
Virtual terminal
Exit from line configuration mode