Interface Types; View Basic Interface Information - Dell Force10 MXL Blade Configuration Manual

Interface Types

The following lists the different interface types.
Interface Type
Physical
Management
Loopback
Null
Port Channel
VLAN

View Basic Interface Information

You have several options for viewing interface status and configuration parameters. The
command in EXEC mode lists all configurable interfaces on the chassis and has options to display the
interface status, IP and MAC addresses, and multiple counters for the amount and type of traffic passing
through the interface. If a port channel interface is configured, the
interfaces configured in the port channel.
Note: To end output from the system, such as the output from the
CTRL+C and FTOS returns to the command prompt.
Note: The command line interface (CLI) output may be incorrectly displayed as 0 (zero) for the Rx/Tx
power values. Perform an simple network management protocol (SNMP) query to obtain the correct
power information.
Figure 13-1
220 | Interfaces
Modes
Possible Default Mode
L2, L3 Unset
N/A N/A
L3 L3
N/A N/A
L2, L3 L3
L2, L3 L2
shows the configuration and status information for one interface.
Requires
Creation Default State
No Shutdown (disabled)
No No Shutdown (enabled)
Yes No Shutdown (enabled)
No Enabled
Yes Shutdown (disabled)
Yes (except L2 - No Shutdown (enabled)
default) L3 - Shutdown (disabled)
show interfaces
show interfaces
show interfaces
command can list the
command, enter