Dell Force10 MXL Blade Configuration Manual page 224

Use the
show ip interfaces brief
Layer 3 data transmission. In
an IP address has been assigned to it and the interface's status is operationally up.
Figure 13-2. show ip interfaces brief Command Example (Partial)
FTOS#show ip interface brief
Interface
TenGigabitEthernet 1/0
TenGigabitEthernet 1/1
TenGigabitEthernet 1/2
TenGigabitEthernet 1/3
TenGigabitEthernet 1/4
TenGigabitEthernet 1/5
TenGigabitEthernet 1/6
TenGigabitEthernet 1/7
TenGigabitEthernet 1/8
Use the
show interfaces configured
To determine which physical interfaces are available, use the
This command displays all physical interfaces available on the switch
Figure 13-3. show running-config Command Example (Partial)
FTOS#show running
Current Configuration ...
!
interface TenGigabitEthernet 9/6
no ip address
shutdown
!
interface TenGigabitEthernet 9/7
no ip address
shutdown
!
interface TenGigabitEthernet 9/8
no ip address
shutdown
!
interface TenGigabitEthernet 9/9
no ip address
shutdown
222 | Interfaces
command in EXEC Privilege mode to view which interfaces are enabled for
Figure 13-2, the TenGigabitEthernet interface 1/5 is in Layer 3 mode because
IP-Address OK? Method Status
unassigned NO
unassigned NO
unassigned YES Manual up
unassigned YES Manual up
unassigned YES Manual up
10.10.10.1 YES Manual up
unassigned NO
unassigned NO
unassigned NO
command in EXEC Privilege mode to view only configured interfaces.
Manual administratively down down
Manual administratively down down
Manual administratively down down
Manual administratively down down
Manual administratively down down
show running-config
(Figure
Protocol
up
up
up
up
command in EXEC mode.
13-3).