Setting Auto-Negotiation Options - Dell Force10 MXL Blade Configuration Manual

Setting Auto-Negotiation Options

The
negotiation auto
forced slave after you enable auto-negotiation.
Caution:
forced-slave. If both are configured the same (that is, both as forced-master or both as forced-slave), the
interface command flaps between an auto-neg-error and forced-master/slave states.
Table 13-5. Auto-Negotiation, Speed, and Duplex Settings on Different Optics
Command
speed 100
speed auto
speed 1000
speed 10000
negotiation auto
duplex half
duplex full
Figure 13-27
252 | Interfaces
command provides a
Ensure that only one end of the node is configured as forced-master and the other is configured as
10GbaseT
mode module
interface-config Supported
mode
interface-config Supported
mode
interface-config Supported
mode
interface-config Supported
mode
interface-config Supported
mode
interface-config Supported
mode
interface-config Supported
mode
shows the auto-negotiation options.
option for configuring an individual port to forced master/
mode
10G SFP+
optics 1G SFP optics
Not supported Not supported
(Error (Error message is
message is thrown)
thrown) (% Error: Speed 100
(% Error: not supported on this
Speed 100 not interface, config
supported on ignored Te 0/49)
this interface,
config
ignored Te 0/
49)
Not supportedNot supported
Supported Supported
Supported Not Supported
Not supported Not supported
(Should some
error message
be thrown?)
CLI not CLI not available
available
CLI not CLI not available
available
show
Copper SFP -
1000baseT Comments
% Error: Speed
100 not
supported on
this interface,
Not supported Error messages
not thrown
wherever it says
not supported
Supported
Not supported Error messages
not thrown
wherever it says
not supported
Not supported Error messages
not thrown
wherever it says
not supported
Invalid Input
error- CLI not
available
Invalid Input
error-CLI not
available