Dell Force10 MXL Blade Configuration Manual page 237

Figure 13-11 shows the port channel's mode (L2 for Layer 2 and L3 for Layer 3 and L2L3 for a Layer 2
port channel assigned to a routed VLAN), the status, and the number of interfaces belonging to the port
channel.
Figure 13-11. show interface port-channel Command Example
FTOS#show int port-channel
Port-channel 1 is down, line protocol is down
Hardware address is 00:1e:c9:f1:00:05, Current address is 00:1e:c9:f1:00:05
Interface index is 1107755009
Minimum number of links to bring Port-channel up is 1
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :lag1001ec9f10005
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Members in this channel:
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:05:44
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 00:05:44
When more than one interface is added to a Layer 2 port channel, FTOS selects one of the active interfaces
in the port channel to be the primary port. The primary port replies to flooding and sends protocol data
units (PDUs). An asterisk in the
As soon as a physical interface is added to a port channel, the properties of the port channel determine the
properties of the physical interface. The configuration and status of the port channel are also applied to the
physical interfaces within the port channel. For example, if the port channel is in Layer 2 mode, you cannot
add an IP address or a static MAC address to an interface that is part of that port channel.
As Figure 13-12
mode, and an error message appeared when an IP address was configured.
Te 0/16(D)
0 packets/sec, 0.00% of line-rate
show interfaces port-channel brief
shows, the interface TenGigabitEthernet 1/6 is part of port channel 1, which is in Layer 2
0 packets/sec, 0.00% of line-rate
command indicates the primary port.
Interfaces | 235