Dell Force10 MXL Blade Configuration Manual page 485

To view the configuration, use the
Figure 28-4 is an example of a configuration to allow a user "john" to view only EXEC mode commands
and all r commands. Because the
snmp-serve
default, found in CONFIGURATION mode, you must also assign the launch command for
CONFIGURATION mode,
Figure 28-4. Configuring a Custom Privilege Level
FTOS(conf)#username john privilege 8 password john
FTOS(conf)#enable password level 8 notjohn
FTOS(conf)#privilege exec level 8 configure
FTOS(conf)#privilege config level 8 snmp-server
FTOS(conf)#end
FTOS#show running-config
Current Configuration ...
!Version E8-3-21-0
hostname FTOS
!
enable password level 8 notjohn
enable password FTOS
!
username admin password 0 admin
Figure 28-5 is a screen shot of the Telnet session for user "john". The
confirms that "john" is in privilege level 8. In EXEC Privilege mode, "john" can access only the
commands listed. In CONFIGURATION mode, "john" can access only the
Figure 28-5. User john's Login and the List of Available Commands
apollo% telnet 172.31.1.53
Trying 172.31.1.53...
Connected to 172.31.1.53.
Escape character is '^]'.
Login: john
Password:
FTOS#show priv
Current privilege level is 8
FTOS#?
configure
disable
enable
exit
no
show
terminal
traceroute
FTOS#confi
FTOS(conf)#?
end
show running-config
snmp-server
, to the same privilege level as the
configure
Configuring from terminal
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Negate a command
Show running system information
Set terminal line parameters
Trace route to destination
Exit from Configuration mode
command in EXEC Privilege mode.
commands are "enable" level commands and, by
snmp-server
The user john is assigned privilege level
8 and assigned a password.
All other users are assigned a password
to access privilege level 8
The command configure is assigned to
privilege level 8 because it is needed to
reach CONFIGURATION mode where
the snmp-server commands are located.
The snmp-server commands, in
CONFIGURATION mode, are assigned
to privilege level 8.
show privilege
snmp-server
commands.
command output
commands.
Security | 483