Enable Proxy Arp - Dell Force10 MXL Blade Configuration Manual

To view the static entries in the ARP cache, use the
(Figure 14-7).
Figure 14-7. show arp static Command Example
FTOS#show arp
Protocol
-----------------------------------------------------------------------------------------
Internet
Internet
FTOS#

Enable Proxy ARP

By default, proxy ARP is enabled. To disable Proxy ARP, use the
mode.
To re-enable proxy ARP, use the following command in INTERFACE mode:
Command Syntax
ip proxy-arp
To view if proxy ARP is enabled on the interface, use the
is not listed in the
the
show config
268
| IPv4 Routing
Address Age(min)
10.11.68.14 94
10.11.209.254 0
command output, it is enabled. Only non-default information is displayed in
show config
command output.
command in EXEC privilege mode
show arp static
Hardware Address Interface
00:01:e9:45:00:03 Ma 0/0
00:01:e9:45:00:03 Ma 0/0
no proxy-arp
Command Mode Purpose
INTERFACE Re-enable proxy ARP.
show config
VLAN
-
-
command in INTERFACE
command in INTERFACE mode. If it
CPU
CP
CP